OVERLOAD PROTECTION
The pump has a built-in thermal overload trip which prevents the pump from
overheating. The pump must be allowed to cool down before restarting. If the
pump will not start again automatically when cooling down, please check the
following conditions;
Is there sufficient water supply? →
add water if necessary
Has the filter become clogged? →
Clean if necessary
Has dirt entered the pump housing? →
follow the cleaning
instructions in the Proper Care and Maintenance section.
Have hoses or jets become clogged? →
Clean if necessary
Has the pump sufficiently cooled down after overheating?
As soon as you have completed this checklist, you can start the
pump again by plugging it back in.
WARNING:
Risk of electric shock – This pump is supplied with a grounding conductor and
grounding type attachment plug. To reduce risk of electric shock, be certain
that it is connected only to properly grounded, grounding-type receptacle
To reduce the risk of electrical shock, use only on portable self-contained
fountains no larger than 5 ft. in any dimension.
Risk of electric shock. Do not remove cord and strain relief. Do not connect
conduit to pump.
This pump has been evaluated for use with water only.
Reduce risk of electric shock during operation of this pump requires the
provision of acceptable grounding
Risk of electric shock – This pump has not been investigated for use in
swimming pool or marine areas.
Do not connect to any voltage other than that shown on the pump
Always disconnect from electrical supply before handling pump.
Don’t operate without water
Operate pump completely submerged for proper cooling
