HALE AP, Техническое руководство

Страница: 116 / 177

104
Table 38. Mechanical Seal Pin Bench Procedure Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
PPE (for Handling Oil) Compressed Air
Shop Hammer Penetrating Oil
1/16-in Pin Punch Grease
(See paragraph 5.7.2 on page 49.)
Drill
*
Loctite LB 8008 (Anti seize Compound)
(Or Equivalent)
#50 Drill Bit
*
2-64 x 1-in Screw
*
Tap (2-64 [UNF] threads)
*
Pin
<See FSG–PL-01487, Sheet 4, Item 33>
Screwdriver (fits #2 screw)
Needle Nose Plyers
*
Optional (for second method).
Perform the following to remove and replace the mechanical seal anti rotation pin.
Pin Removal
NOTES
This method ONLY works, if the grease has a very heavy consistency and the punch
fits very tightly into the bore of the pin without binding against the sides of the pin.
The combination of the two allows the grease to be forced under the pin pushing it
out of the blind hole.
When the punch nears the end of the pin/bottom of the blind hole, remove the punch
and refill the pin with more grease.
If after several attempts of using the first method the pin has NOT moved, use the
second method to remove the pin.
A. Use first method to remove pin as follows.
Soak pin and blind hole with abundant quantities of penetrating oil. 1.
Wait for penetrating oil to work. 2.
Remove excess penetrating oil. (Compressed air and shop rags.) 3.
Fill hole/pin with heavy grease. (See paragraph 5.7.2 on page 49.) 4.
Align a 1/16-in pin punch with bore in pin. 5.
Using a hammer, strike punch. (NOTE: Refill grease often as required be- 6.
tween hammer strikes.)
B. Otherwise, use second method to remove pin as follows.
Using a drill and #50 drill bit, prepare bore of pin for tapping. 1.
Tap pin bore for 2-64 (UNF) threads. 2.
Use a 2-64 x 1-in screw, remove pin from blind hole as follows. 3.