11
10 watt HID Light Head Operation
Halcyon's 10 watt HID light head encases the bulb, lens, ballast and
reflector in a very tough, focusable Delrin body. The daylight-quality HID
bulb is attached directly to the ballast to increase positive ignition and
bulb longevity.
The 10 watt HID Light head is adjustable from a flood to a tight spot, or
any spread in between. Beam focus is adjusted by the knurled, integrated
knob at the back of the light head, eliminating the need for a lock-down
screw. The entire range of focus requires less than 1.5 revolutions. Do not
attempt to force the action past the designed limits, in either direction,
as damage can occur.
Should the bulb in your Halcyon 10 watt HID Light become damaged, it
can be easily replaced by following these simple steps:
1. Begin disassembly by removing the steel retaining ring from the
inside edge of the front bezel (Figure 1). Use a small screwdriver to pry
the retaining ring out of its slot.
2. Remove the lens. The reflector and bushings should spring up so it can
be removed. Remove the spring to access the bulb. The disassembled
light head includes the retaining ring, the lens, the bushing, the re-
flector, and the spring (Figures 2, 3).
3. Install the new bulb and reverse the procedure to reassemble the light
head. Note the notch in the socket and the corresponding ridge on the
bulb (Figures 4, 5) Make sure to clean all appropriate parts before re-in-
stalling.
Be careful during reinstallation to ensure that the reflector
and bushing are tightly seated– the lens should sit flat against the
O-ring.
4. Carefully ease the retaining ring back into its guide groove, all the
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7