Halco J&J Electronics ColorSplash VU LPL-R1C-12 Series, Инструкция по установке и эксплуатации

Страница: 7 / 16

11 12
Show:
Slow color-fade through orange, red and magenta.
Cycle:
Continuous color sequence cycle with cross-fade between colors.
6. DESERT SKIES:
Show:
Fast color-change through random colors.
Cycle:
Light will hold on each color for 2 seconds before changing to the next color.
7. NOVA:
8. PARISIAN BLUE:
Solid Deep Blue
9. NEW ZEALAND GREEN:
Solid Deep Green
10. BRAZILIAN RED:
Solid Deep Red
11. ARCTIC WHITE:
Solid White Hue
12. MIAMI PINK:
Solid Deep Pink
1. Verify the VÜ Nicheless LED Underwater Light has been disconnected from the power source
and be sure the light fixture is in a dry environment. Remove the screws from the lens with
the tool provided. Pull the lens from the body of the fixture.
2. Using the tool provided, insert and turn the threaded portion into the extraction hole in the
face of the light cartridge. Pull the light cartridge from the body of the housing.
3. Insert the replacement cartridge into the body of the housing. Line up the tab at the end of the
circuit board with the receiving slot inside the body of the housing. It may be necessary to
slowly turn the light cartridge until the tab lines up with the slot.
4. Clean the lens and the enclosure of any remaining old silicone sealer before applying new silicone
and replacing the lens. Replace the O-ring with the new one provided. Attach the lens onto the
fixture body. Tightly secure the screws . Once all screws are tight, slowly submerse the fixture in water,
checking for any air bubbles. Immediately remove fixture from water if air bubbles appear, as this indicates
the seal is not on correctly, leaving it not water tight. Retighten the screws and test for air bubbles again.
5. Reset the fixture into the wall fitting and trun the power on.
Which could result in serious injury or death. The
VÜ Nicheless LED Lights
are only available for 12VAC
power. For supply connection, use only an isolating low voltage power supply with ungrounded output,
evaluated and listed by a Nationally Recognized Testing Laboratory (NRTL) for swimming pool use.
RISK OF ELECTRIC SHOCK OR ELECTROCUTION.
WARNING
LIGHT CARTRIDGE REPLACEMENT
The water level should be lowered to approximately 12 inches below the pool lights. Be certain the water
is drained out of the wall housing. Minimum pool safeguard requires dropping the water level 2 inches
to 4 inches below the light. NEVER remove water from the pool without checking ground water tables.
WINTERIZING
Consult a local state or city swimming pool professional for proper winterization of
your
VÜ Nicheless LED Underwater Light Fixtures.
WARNING
Use the following tips to help you resolve problems that might occur while operating the
VÜ Nicheless LED Underwater Light Fixtures.
TROUBLESHOOTING
Problem Possible Cause/Action
All lights fail to
illuminate
One or more lights
are dim, blinking or
not working
Colored lights out
of sync
Lights are not receiving
power
Poor connection of
improper wire gauge
Improper voltage
supply or poor
connection to the light
Check 120VAC power supply into transformer.
Check for 12VAC output at transformer. Check
or reset GFCI. Make sure 120 volts has not been
used in the installation - damage is assured and
will void the warranty.
Separate each light and independently wire
12VAC to this single light only. Repeat this pro-
cess on each light. If junction box is being used,
check for proper connection of light cord. Verify
that the correct wire gauge is being used
between the transformer and the j-box.
Verify that proper wire connections are being
achieved for the lights that are out of sync. Reset
all the lights to white by turning lights OFF for
five (5) seconds, then turning ON.