Warranty Information:
This product is warranted for five years from the date of purchase. If this product does not perform to the specifications supplied on this package, send an email or write to the
address below for product return and replacement. This replacement is the sole remedy available. Liability for incidental or consequential damage is expressly excluded.
Visit www.halcolighting.com for full warranty details and compatibility information.
© 2018 Halco Lighting Technologies, LLC. All rights reserved. Halco and ProLED are registered trademarks of Halco Lighting Technologies. All sizes and specifications are subject to change. Print Edition 12-18-18
Halco Lighting Technologies | 2940 Pacific Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone 770.242.3612 | Fax 800.880.0822 | halcolighting.com | Atlanta | Cleveland | Houston | Los Angeles | Phoenix
I
mportant Safety Information:
CAUTION: This luminaire must be wired in accordance with the National Electrical Code and applicable local codes and ordinances. Proper grounding is
required to insure personal safety. Carefully observe grounding procedure under installation section.
CAUTION: Installation and servicing of this equipment should be performed by qualified personnel only.
CAUTION: Do not mount near gas or electrical heaters.
CAUTION: Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
CAUTION: The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any modification or use of non-
original components will void the warranty and product liability.
CAUTION: Do not use this equipment for other than intended use.
CAUTION: Do not install in dead air, sheltered, buried or boxed in location. This luminaire should not be installed in areas that will entrap heat. It is not
intended to be used in potentially dangerous or hazardous locations such as flammable or explosive atmospheres.
CAUTION: This luminaire is not for use with UL924 Emergency Lighting Equipment.
1. Install the Visor as shown in the figure, Screw across flat washer
-Visor-Frame-Nylon flat washer-put nut on-fix Frame
Using flat head screw
driver to remove the
waterproof plug head
on the right side of
fitting
Using flat head screw
driver to remove the
waterproof plug head
on the right side of
the fitting
Introduce the line of Motion sensor to the inside
of fitting and fix the cable gland self-contained.
Install the
motion sensor
here
Put the photocell on
the same position, fix
the nut from the
external of fitting.
1. Fix the High voltage driver onto the gear plate
1. Installation of Beauty Plate fixed on the backside of the fitting as
shown in the figure
Installation Instructions for Visor
Installation Instructions for 347-480V driver
Installation Instructions for Photocell
Installation Instructions for Motion Sensor
Wiring diagram for High voltage driver
Wiring diagram for Photocell
Wiring diagram for Motion Sensor
Installation Instructions for Beauty Plate
Open Frame
Open Frame
Open Frame
