Hal Communications ST-6000, Инструкция по эксплуатации

Страница: 11 / 70

2-4
Rear Panel Connections:
AC power input (unlabeled): Universal U.S./European standard connector for 120/240 VAC
non-captive AC power cords.
MOTOR: Three-prong AC socket to supply printer motor power con-
trolled by the autostart circuitry. The voltage available is the
same as the power line voltage to the ST-6000.
Ground (ground symbol) Cabinet ground connection for safety and RF ground connec-
tion.
AC POWER .5 A - SB: AC power fuse for ST-6000 only (not for the MOTOR socket).
LOOP .1 A: Loop power supply fuse.
LOOP 1 & 2: Main and auxiliary loop switch connections internal loop power
supply connection, CW-ID hand key connection.
LOOP 3: Additional series loop connection that can be used with loop 1
or loop 2.
KOS: KOS control line
Keyboard connection
RS-232 / MIL-188: Data input,/output connections for EIA-RS-232C and MIL-STD-
188C connections, CW-ID hand key connection.
SCOPE: Connection for external X-Y oscilloscope display.
AUXILIARY CONTROL: 15 pin connector to provide access to many control and signal
lines of the ST-6000. A circuit-board jumper plug is furnished
to make "normal" jumpers.
AUDIO OUTPUT: Balanced 500 ohm tone keyer output.
AUDIO INPUT: Balanced 500 ohm demodulator tone input.
NOTE: All of the above specifications are nominal, design-center values and may vary in produc-
tion units by as much as ±10 %. HAL Communications Corp. reserves the right to alter any
specifications without prior notification.