HAKO Hakomatic E 430, Инструкция по эксплуатации

Страница: 20 / 30

4.6 Electrical equipment
E Fuse for vacuum motor
F Over load protector
brush motor
The electrical equipment of the Hako-
matic E 430 uses a mains voltage of
230V/50 Hz AC.
Easy access to brush motor and
suction turbine is possible after the up-
per part of the unit has been titled to
upside.
The suction turbine has been provided
with a fuse (E ) having a rating of T6A.
It must be replaced by a fuse of same
rating (T stands for Time -lag).
Suction turbine require little mainte-
nance only; just the carbon brushes
must be checked- renewed, if requi-
red- after every
200 service hours.
The brush motor is protected by a cur-
rent sensitive overload protector ( F )
which requires to be manually reset in-
case of tripping. When brush motor
trips identify the cause and correct it
before trying to run the machine.
The protector can be reset by pressing
the transparent dome on the electrical
box cover. Please allow approximately
30 seconds time before resetting.
Note: If there should be repeated
cases of failure, look for the reason.
Any work at the electrical system has
to be carried out by specialized electri-
cians only.
Whenever performing work at the
electrical system, disconnect the
mains supply plug on principle. When
work at the electrical system is finis-
hed, a safety test,( as per VDE 0701,
sections 1and 3, has to be performed).
18
4. Inbetriebnahme
E
F
Fig.15
4.6 Electrical equipment
E Fuse for vacuum motor
F Over load protector
brush motor
The electrical equipment of the Hako-
matic E 430 uses a mains voltage of
230V/50 Hz AC.
Easy access to brush motor and
suction turbine is possible after the up-
per part of the unit has been titled to
upside.
The suction turbine has been provided
with a fuse (E ) having a rating of T6A.
It must be replaced by a fuse of same
rating (T stands for Time -lag).
Suction turbine require little mainte-
nance only; just the carbon brushes
must be checked- renewed, if requi-
red- after every
200 service hours.
The brush motor is protected by a cur-
rent sensitive overload protector ( F )
which requires to be manually reset in-
case of tripping. When brush motor
trips identify the cause and correct it
before trying to run the machine.
The protector can be reset by pressing
the transparent dome on the electrical
box cover. Please allow approximately
30 seconds time before resetting.
Note: If there should be repeated
cases of failure, look for the reason.
Any work at the electrical system has
to be carried out by specialized electri-
cians only.
Whenever performing work at the
electrical system, disconnect the
mains supply plug on principle. When
work at the electrical system is finis-
hed, a safety test,( as per VDE 0701,
sections 1and 3, has to be performed).
18
4. Inbetriebnahme
E
F
Fig.15