NOTE:
The FM-202 is preset at 750
°
F. at the factory.
Check the temperature setting by pressing the
button.
The set temperature will be displayed for two seconds.
●
Factory settings
The FM-202 comes from the factory with the
following values preset:
Temperature scale
Auto power shutoff
Low temperature alarm setting
Resetting the supervisor or
operator control setting
Set temperature
Fahrenheit
disabled
300
°
F
750
°
F
Tip ID controlled
with inserting the
card.
6
CAUTION:
Refrain from inserting foreign objects, the wrong end of
the tip, or incompatible tips into the process gate.
Damage may result.
NOTE:
If the buzzer sounds three times when the tip is inserted
into the process gate, there has been a reading error.
Reinsert the tip.
When a tip ID has not been entered, or when a
tip is NOT inserted into the FM-2021, the
following procedure obtains:
1. Turn the power switch ON.
2. The display will show
(Tip ID number)
and the LED on the connector will flash. The
display will show the set temperature and
.
3. Enter tip ID as follows:
Insert the tip ID end of the tip into the
process gate until the buzzer sounds ONCE.
Tip ID data are displayed for one second.
The display then shows
. The LED
indicator will stop flashing, indicating that the
data are now stored. Once the tip is inserted
into the connector, heat control begins.
4. When the set temperature is reached, the
buzzer sounds and the heater lamp at the
lower right of the temperature display starts
blinking.
When a tip ID has been entered, or when a tip
IS inserted into the FM-2021, the following
procedure obtains:
1. Turn the switch ON.
2. The display will show the initial temperature
setting.
3. Heat control begins.
Tip ID displayed.
Set temperature displayed.
Turn the switch
ON.
Heat control begins.
Tip
inserted
?
XX
Enter tip ID.
Insert tip
Y
N
Set temperature.