![background image](http://html1.mh-extra.com/html/hakko-electronics/fr410-52/fr410-52_instruction-manual_3331462022.webp)
21
●
Initial Reset
After completing settings, if you press the “ENT” button again in the selection
screen, you will return to the normal display.
Initial Reset allows the factory default settings to be restored.
1. Move the cursor to select “Initial Reset”.
After selecting, press <ENT>.
2. Using the <
↑
> or <
↓
> button, select
either C or F. To stop Initial Reset, scroll
the screen to select <Exit>.
3. After selecting it, using the <
↑
> or <
↓
>
button, select OK or Cancel.
CAUTION
Even when Initial Reset is finished, “Pass. Lock” and password settings remain.
<↑>
<↓>
<ENT>
Re a d y A l a r m
P a s s . L o c k
I n i t i a l R e s e t
OFF
OFF
<↑>
<↓>
<ENT>
I n i t i a l R e s e t
゚ F
<↑>
<↓>
<ENT>
I n i t i a l R e s e t
゚ F
<↑>
<↓>
<ENT>
P a s s . L o c k
I n i t i a l R e s e t
< E X I T >
OFF
22
Replacing the filter
Replace the filter as shown following steps
A to C. During operation, the filter pipe is
very hot. Wait until the filter pipe is cool before
replacing the filter or cleaning.
We recommend keeping a second filter pipe
containing new filters handy, and replacing
the installed filter pipe with this secondary
filter pipe.
B. Pull
A. Down
C. Replace the entire filter pipe with
a secondary filter pipe.
Release Knob
7. MAINTENANCE
WARNING
Since the desoldering tool can reach a very high temperature, please work carefully.
Except when cleaning the nozzle and heating element, ALWAYS turn the power switch
OFF and disconnect the power plug before performing any maintenance procedure.
Properly maintained, the HAKKO FR-410 desoldering tool should provide years of good service.
Efficient desoldering depends upon the temperature, nozzle selection, and proper routine
maintenance. Perform the following service procedures as dictated by the conditions of the
station's usage.
During suction, the gauge indicating suction force
is shown at the bottom of the screen.
If "CHK" appears on the display, check the nozzle
and heater for restrictions.
If the nozzle or heater are clogged, clean or replace
them.
F
Suction gauge
Sign of clogging
C H K
CAUTION
The section from the heating element
to the filter pipe is provided with pipes
through which melted solder passes,
so it may become very hot. Be very
careful when handling this section.
CAUTION : HOT AREA
Содержание FR410-52
Страница 32: ...11 PARTS LIST 31 Pump assembly 23 21 24 22...
Страница 35: ...12 WIRING DIAGRAM 34 Inlet Power switch...