2
When the power is ON, the nozzle temperature is between
380˚C and 480˚C (716˚F and 896˚F).
Since mishandling may lead to burns or fire, be sure to comply with
the following precautions.
Safety Instructions
Warnings, cautions are placed at critical points in this manual to direct the operator’s
attention to significant items. They are defined as follows:
WARNING
WARNING: Failure to comply with a WARNING may result in serious injury or death.
CAUTION : Failure to comply with a CAUTION may result in injury to the operator, or
damage to the items involved.
For your own safety, be sure to comply with these precautions.
CAUTION
Remove the pump securing screws (M4x25 marked red)
from the bottom of the station.
Failure to do so may result in serious problems.
To prevent accidents and failures, be sure to take the following precautions:
·Do not use the unit for applications other than desoldering.
·Do not rap the desoldering gun against the work bench to shake off
residual solder, or otherwise subject the iron to severe shocks.
·Do not modify the unit.
·Use only genuine Hakko replacement parts.
·Do not wet the unit or use the unit with wet hands.
·Set the ceramic paper filter (S) for the filter retainer (station), and the
ceramic paper filter (L) for the filter pipe (gun).
·Maintain the desoldering gun and the station.
·While using the unit, don't do anything which may cause bodily harm
or physical damage.
·Do not touch the metal parts near the nozzle, nearby plastic parts and
the spring iron holder .
·Do not use the product near flammable items.
·Advise those in the work area that the unit can reach very high
temperatures and should be considered potentially dangerous.
·Turn the power OFF when no longer using the Hakko 470B or when
leaving it unattended.
·Before replacing parts or storing the unit, allow the unit to cool and then
turn the power OFF.
