Hakko Electronics 373, Инструкция по эксплуатации

Страница: 4 / 15

Setting Up the HAKKO 373
1. Install the Solder Dia.
Adjustment Ring
1. Remove the tension gear guide shaft.
2. Attach the solder dia. adjustment ring according to the
diameter of your desired solder and attach the tension
gear guide shaft.
Solder Dia.
Adjustment Ring
Tension Gear Guide Shaft
Tension Gear
2. Setting the Guide Pipe
Asse’y
Set the guide pipe asse’y between the nipple (or nut) and
handle, and secure it. Washer may need depend on the type
of iron. Please refer to the following figure.
3
Setting up should be done while the soldering iron is cool, or you may get burnt.
Do not force the guide pipe bend or turn as this may result in damage.
Do not operate with tube bending or holding in sharp angle. It may cause to clogging.
Guide Pipe Asse’y
Handle
Nut
HAKKO 900, HAKKO DASH SERIES & 907, 908
Handle
Guide Pipe Asse’y
Nipple Wave Washer (No. B2684)
HAKKO 902, 903, 904
Handle
Guide Pipe Asse’y
Nut
Ring Washer
HAKKO MACH-I SERIES
(for 918 – No. B2685)
(for 920, 921, 922 – No. B2686)