7 / 19
HakkiFeed 422 rev. A
Translated
Version 1-2019
If a fault occurs during the test run, determine the cause of the fault and take remedial action as deemed
necessary. The machine must be shut down and disconnected from the power source for the duration of both
the diagnostics and repairs.
4.2.
Loading logs onto the log rack
Use a forklift or tractor with a sufficiently long fork to ensure safe loading.
-
Load the first log against the feeder – do not drop the log.
-
Lower the following logs carefully on the rack – do not drop them.
-
Load the logs on the machine with the stem end first, and ensure that the centre of gravity is in the
middle so that the logs cannot tip to the side off the rack.
-
Do not exceed the load-bearing capacity of the rack (
), and leave enough room for the free
operation of feeder C.
-
Smaller logs can be stacked on top of each other, but a total height of 40 cm must not be exceeded.
Note! Ensure that there are no other people in the vicinity of the machine when loading logs!
Note! Ensure that the log’s centre of gravity stays on the conveyor!
5.
Machine maintenance
The machine must be disconnected from its power source before any maintenance, adjustment, replacement
or cleaning measures. Only use spare parts that are supplied by the manufacturer or your retailer. If any of the
machine’s guards or components need to be removed for maintenance, they must always be reattached
before the machine is activated. After maintenance and adjustment measures, a test run must be carried out
on the machine, according to the instructions in Section 4.1.
5.1.
Tightening
Check the tightness of the log rack bolts at regular intervals. Inspect the rack visually before each instance of
use.
5.2.
Lubrication
There are a total of six lubrication points in the machine, presented in the figures below.
1.
In-feed conveyor bearings (B) 2 pcs,
Figure 6:B
(every 200 hours)
2.
Feeder bearings (A) 2 pcs,
Figure 6:A
(every 200 hours)
3.
Feeder cylinder nipples 2 pcs,
Figure 6:C
(every 50 hours)
Note!
Take care when applying grease to dustproof bearings!
