Haiyang Stella Series, Руководство пользователя

Страница: 127 / 136

- 127 -
dry paper.
Do not use solvents to clean your transducer. The high impact polycarbonate housing is very durable
but solvents will destroy it. Keep acetone, MEK, lacquer thinner and most other thinner/solvents away
from your transducer.
Through-hull Transducers
Through-hull transducers are recommended for in-boards and other vessels with disturbed water flow
under the transom. HAIYANG offers several models of bronze through-hull transducers. To enjoy the
full capability of your Sonar, select a dual frequency model with temperature sensor. Sturdy bronze
construction assures a secure installation and provides a strong base for fairing blocks, if needed, to
compensate for hull shape.
The transducer should be installed in a location free of bubbles and away from disturbed water flow.
Smooth water flow around the transducer and along its surface is very important for consistent
operation.
Areas in the center third of water line length at cruising speed are usually satisfactory.
Locations forward of the engine and in a flat area near the center line of the boat are preferred. Do not
install the transducer behind water intakes, other through-hull fittings or irregularities in the hull.
Dead-rise
On hulls with dead-rise of 5 or less, the transducer may be mounted directly through the hull. Where
dead-rise is greater than 5, fairing blocks must be used to orient the face of the transducer parallel
with the water surface.
In this case, no fairing block is necessary. To prevent leakage, any gaps between the stem threads
and holes drilled in the hull should be completely filled with waterproof marine sealant.
Tighten the stem nuts securely but do not over tighten. In this situation, install fairing blocks both
inside and outside the hull. Install the transducer with the face aiming straight down. To prevent
leakage, any gaps between the stem threads and holes drilled in the hull should be completely filled
with waterproof marine sealant. Tighten the stem nuts securely but do not over tighten.