Haivision Makito, Руководство пользователя

Страница: 61 / 294

Managing the Encoder
Accessing the Encoder
Makito User’s Guide, v2.1.0, Issue 01 61
Accessing the Encoder
Web Interface
To access the encoder configuration Web page:
1.
From your computer, open a Web browser.
2.
Type the encoder’s IP Address in the browser’s address bar (see “Default Encoder IP
Address” below) and press Enter.
3.
Log in (see “Logging In to the Web Interface” on page 64).
Security Steps
Only secured HTTP (HTTPS) is supported for the Web Interface; therefore, a server certif-
icate is required. The encoder automatically generates a self-signed certificate and your
browser will recommend that you do not proceed.
If you have not changed the factory defaults on the encoder, a certificate with factory
default subjects exists (DNS: haivision-ace, IP:
10.5.1.2
). Proceed temporarily if you can,
since this default certificate will be deleted and re-generated (see below).
If you or your system administrator do not install your own certificate, a new one will be
generated upon reboot the first time a non-factory IP address is detected with the configured
hostname, DNS, and IP address. Accept this certificate and proceed to the Web Interface.
CLI
To access the encoder CLI:
1.
Open a telnet session to the encoder (see “Default Encoder IP Address” below).
2.
At the login prompt, type the username and password (see “Role-based
Authorization” on page 62).
Default Encoder IP Address
NOTE
If you haven't changed the factory presets, and if not specified elsewhere in the
shipment, the encoder’s IP Address is set by default to: 10.5.1.2 .
To be able to log in to the Makito Web interface, your computer has to be in the same IP
Address range (subnet).
You may have to temporarily change your computer’s IP Address to be in the same subnet
as the encoder. Only then you will be able to access the encoder and change the encoder's
IP Address, and then afterwards change your computer's IP Address back.