Haivision F-MB21B-R, Руководство пользователя

Страница: 47 / 420

Installing the Encoder
Connecting the Encoder to the Network and a Computer
Makito X User’s Guide, v2.2, Issue 02 47
To set up the serial interface:
1.
Connect the Makito X’s COM1 port to your computer as described in the previous
section, “Connecting the Encoder to the Network and a Computer” .
2.
Power up the computer and start the serial communication application.
3.
Set up the terminal parameters as follows:
4.
Power up the Makito X. (See “Powering Up the Unit” on page 55.)
5.
From the serial communication application, press
Enter
to get a prompt from the
Makito X.
It takes approximately two minutes for the Makito X to boot. The system will request
a login, or display the shell prompt if an active session is still running.
TIP
You can view the COM port settings from the Web interface. For information, see
“Managing the COM Port” on page 195.
We recommend that you log out from the Makito X and exit from the serial communication
application
before
disconnecting the COM1 port.
COM1 Serial Port RJ45 Pinout (Makito X SDI only)
The COM1 serial port uses an RJ45 connector which has the following pinout:
Parameter Setting
baud rate
115,200 bps
data bits
8
parity
None
stop bit
1
flow control
None
Table 2-1 COM1 Serial Port RJ45 Pinout
Pin # Signal RS-232 Signal RS-422
1
Not connected Not connected
2
Not connected Received Data -
3
Not connected Transmitted Data +
4
Signal Ground Signal Ground
5
Received Data Received Data +
6
Transmitted Data Transmitted Data -