Haivision F-MB21B-R, Руководство пользователя

Страница: 195 / 420

System Administration and Storage
Managing the COM Port
Makito X User’s Guide, v2.2, Issue 02 195
Managing the COM Port
NOTE
The COM Port page only accessible to administrators. However, operators can
configure the COM port settings from the Metadata page when the COM port is in
Metadata mode.
The Makito X with SDI provides a serial interface that you can use to connect to a computer
for management of the encoder. The COM Port page displays the serial COM port settings
and provides the option to switch from Metadata to Management mode.
On systems with the Metadata Capture option installed, you can use the serial COM port
interface to capture either KLV or CoT metadata. For more information, see
“Configuring
Metadata Capture” on page 102.
In order to configure the COM port settings to capture metadata, you need to set the COM
Port Mode to Metadata and then reboot the encoder. You can then configure the COM port
settings from the Metadata page (see
“Configuring Metadata Capture” on page 102).
In order to configure serial pass-through to control devices such as PTZ cameras, you need
to set the COM Port Mode to Pass-Through and then reboot the encoder.
To manage the COM Port settings:
1.
On the Administration page, click
COM P
ORT
from the sidebar menu.
The COM Port page opens, as shown in the following example.
2.
(If applicable) Select
Metadata
from the COM Port
Mode
drop-down list.