HAIRUIS P1, Руководство пользователя, Страница: 14 / 22

2.7 Probe Mode
There are three probe modes: AUTO, MAG and EDDY. In AUTO mode, the probe can automatically determine
the type of substrate measured. In MAG mode, the probe can only measure on magnetic substrates. In EDDY
mode, the probe can only measure on non-ferrous metal substrates. When a magnetic substrate detected, an
“F” will be shown on the right of readings, and when a non-ferrous metal detected, a “N” will be shown. User
can switch probe mode as below.
a. Press “Left Key” once to enter into menu mode(”Root” directory);
b. Press “Up Key” or “Down Key” to activate “Options” item, and press “Left Key” once to enter in;
c. Press “Up Key” or “Down Key” to activate ”Probe Mode” item, and press “Left Key” once to enter in;
d. Press “Up Key” or “Down Key” to activate your intended item, and press “Left Key” once to select the item
and go back. Press “ZERO Key” to back measure mode.
2
.
8 Storage
In general group mode(GENn), readings and statistics will be stored and not be lost when power off. In direct
group mode(DIR), readings and statistics will be lost when power off.
Each group has individual high/low limit alarm, zero calibration and multi-point calibration, user can change
these settings, and they will be stored.
In addition, user can set the system settings(e.g.: Measure Mode,Group Mode,Probe Mode etc.), these settings
will also be stored.
2.9 Recall and Delete Readings
Delete the last readings(Tips: If in measure mode, press the “UP Key” once by one beep).
a. Press “Left Key” once to enter into menu mode(”Root” directory);
Note
:
When battery low, user must replace the battery timely. Before replacing the battery, you need to power off
the gauge firstly.
12