• Charge your LaserComb
by placing the
power cord directly into the handle end of
the LaserComb (Figure A).
For initial charging, allow 2-3 hours to fully
charge your LaserComb.
The indicator light on the power button will
flash red during the charging process. Once
charging is complete, the light will stop
flashing and remain on.
• Turn on the LaserComb
by pressing the
power button and hold until power button
light turns on.
Next, press the laser button until it lights up.
That means the LaserComb is ready for use
(Figure B).
The HairMax LaserComb® is a very effective device when used
correctly. It is manufactured using precision components and
should last 10-15 years under normal usage. Please take time to
read the entire User Manual before operating the LaserComb.
Prima 7 LaserComb Model
Use the Prima 7 for 15 minutes, 3 times a
week. The treatments should be spaced
every other day, for example Monday,
Wednesday, Friday. Move the LaserComb
slowly 1/2 inch every 4 seconds.
It is recommended, but not essential, that the LaserComb be used
on a clean scalp after washing. Your hair can be wet, towel dried or dry.
The LaserComb should be used prior to applying any topical treatments,
gels, sprays or concealing products.
Laser Light - Avoid Direct Eye Exposure
The HairMax Prima 7 is indicated to treat Androgenetic Alopecia, and promote hair growth in
males
who
have Norwood Hamilton Classifications of IIa to V and in
females
who have Ludwig (Savin) I-4, II-1, II-2,
or frontal patterns of hair loss and who both have Fitzpatrick Skin Types I to IV.
• Before beginning treatment,
be sure to test
the LaserComb for sensitivity (see page 5 of
your User Manual). To start your treatment
place the LaserComb flat on your scalp so
that both rows of teeth are touching
the scalp (Figure C).
• Start at your hairline.
Move the LaserComb
from front to back of scalp in a slow combing
motion, stopping every ½ inch (1cm) and
pausing for 4 seconds (Figure D). Do not lift
the LaserComb off your scalp while combing
from front to back.
• Lift the LaserComb off your scalp
and start
at a new position at the hair line. Continue in
this manner from front to back and then side
to side (Figure E) until you cover your entire
scalp with multiple passes. When the
LaserComb is on it will beep and vibrate every
four (4) seconds. This means that it is time to
move the LaserComb to the next area of the
scalp. Repeat these passes for the total
treatment of 15 minutes.
• If you have long hair,
use your fingers
to lift your hair out of the way while using the
LaserComb to be sure that the laser energy
reaches your scalp (Figure F).
• After treatment,
turn off the LaserComb by
pressing and holding the power button (lower
button) until the indicator light turns off
(Figure G).
A
B
G
C
F
D
E
156719-1_Lex.indd 2
156719-1_Lex.indd 2
2/13/15 8:15 PM
2/13/15 8:15 PM
Process Cyan
Process CyanProcess Magenta
Process MagentaProcess Yellow
Process YellowProcess Black
Process Black
