HAIRCUT TH35, Руководство пользователя

Страница: 26 / 28

EN
26
3.3. ADJUSTING THE CUTTING HEIGHT WITH THE LEVER
The cutting height can be adjusted during use of the clippers, with the adjusting
lever (Fig. 1-C):

Push the lever upwards to reduce the cutting height.

Push the lever downwards to increase the cutting height.
3.4. USING THE COMB ATTACHMENTS

The clippers must be switched off. Select a comb attachment
(Fig. 1, refs. E-J).

Place the comb attachment on the blade and clip it in at the rear. When the
comb attachment is correctly fixed, it is immobilized.
3.5. REPLACING CUTTERS

Switch the clippers off and unplug the power pack from the mains power
supply.
 Take the screws out of the cutters (Fig. 3) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:

Set the adjusting lever to the minimum cutting height.
 The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.

The upper and lower cutters must be set parallel.

The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.

The other end tooth on the upper cutter (on the right-hand end) must also
touch the corresponding end tooth on the lower cutter (on the right-hand end).

Tighten the two screws (Fig. 4).