vario quick
Installation
Order h49 7144.907-333
11
5.3 Setting the stop height
INFORMATION
The stop height can only be adjusted in steps of 1 mm.
Adjustment outside these specified steps is not per-
mitted.
An adjustment of 1 mm corresponds to a half turn of
the stop screw. A half turn is indicated by the stop
screw engaging in the base end-stop disc.
1. Turn the stop screw to adjust the stop height. Observe
the minimum required clamping depth of the clamping
device [see operating instructions of the clamping de-
vice].
5.4 Machining a blank screw
To be able to machine the blank screw, the clamping device
must already be mounted on the machine.
1. Remove the clamping element of the clamping device
[see operating instructions of the clamping device].
2. Remove the changing parts of the clamping device [see
operating instructions of the clamping device].
3. Mount the clamping element suitable for the clamping
sleeve [see operating instructions of the clamping de-
vice].
4. Place the clamping sleeve on the blank screw.
