Key Points in Installa tion, Adjustment
and Disassembly
Confirm the water faucet
Conn ectio n betw een th e water in let hos e jo in ter and th e water faucet
Water faucet, suitable
Water faucet, not suitable
It is required that the front end shall be longer than 10cm.
The outlet end surface of the faucet shall be flat and smooth. If not please file it to
avoid leakage.
3.Fasten the four screws evenly. See to Figure 4.
4.T ake off the nameplate. T wist the fastening nut as per the indication of the figure to
seal up the outlet end surface of the faucet. See to Figure 5.
Remarks:
Before installation, the threading is 4mm above the upper surface of the nut. After
installation, the threading is 2mm above the upper surface of the nut. See to Figure 6.
Nut
About 4mm
before twisting;
about below 2mm
after twisting
Figure 5)
Figure 4
Figure 6
Screw
Screwdriver
Nameplate
Bushing
Figure 2
Figure 1
Figure 3
Slider
Water inlet hose jointer
Water inlet hose
Lock lever
Outlet end surface
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet
hose jointer from the water inlet hose component.See to Figure 1.
2.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet
hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be
set on the water faucet, please loosen the four screws and take out the bushing in the
jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to
Figure 3.)