Haier WQP12-EFMS, Руководство по обслуживанию

Страница: 14 / 30

Parts and functions
Salt
The hardness of the water varies from place to place. If hard water is used in the
shwasher,deposits will form on the dishes utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to
eliminate lime and minerals from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
- Remove the lower rack and then unscrew and remove the cap from the salt container;
- If you are filling the container for the first time, fill it with water;
- Place the end of the funnel(supplied) into the hole and introduce about 2 kg of salt.It is
normal for a small amount of water to come out of the salt container.
- Carefully screw the cap back on.
M The salt container must be filled when the "low salt" indicator light (located on the control panel)
comes on.
To prevent the formation of rust,load the salt just before beginning a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount of salt
consumed based on the hardness of the water used.This is intened to
optimize and customize the level of salt consumption so that it remains at
a minimum.Your local Water Board can supply the degree of hardness of
the water in your area.
To adjust salt consumption,proceed as follows:
- Unscrew the cap from the salt container;
- There is a ring on the container with an arrow on it (see figure to
the side), If necessary, rotate the ring in the anticlockwise
direction from the "-" setting towards the "+" sign, based on the