English
PROPER LOCATION
• To ensure that your water dispenser works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation and electrical connections.
• The following are the recommended clearances around the water dispenser.
Sides
3/4" (19mm)
Back
2" (50mm)
• Do not install your water dispenser in any location that is not properly insulated
or heated because the unit is not designed to operate in temperature settings
below 55˚F / 13˚C.
Note
:: The built-in thermostat maintains the hot and cold temperatures
automatically. On the compressor cooled water coolers the hot water
temperature will be between 185˚-197˚ F/ 85˚-92˚ C and the cold
water temperature will be between 42.8˚-50˚ F/ 6˚-10˚ C.
On the thermal electric cooled water coolers the hot water temperature
will be between 185˚-197˚ F/85˚-92˚ C and the cold water
temperature will be between 50˚- 59˚ F/ 10˚-15˚ C.
• Select a suitable location for the unit on a hard even surface away from direct
sunlight and heat sources (e.g., radiators, baseboard heaters, cooking
appliances, etc).
Note:
Hot and cold water will not be instantly available as the unit will
need time to heat up and cool down the water.
CAUTION: DO NOT plug in the water dispenser until water flows
through both Hot and Cold water faucets.
ASSEMBLY INSTRUCTIONS
Read carefully and understand all installation instructions before installing the
water dispenser.
Installing Your Water Dispenser
Follow the steps below to install the water dispenser.
1. Remove the cap from the water bottle first. Lift up the water
bottle and quickly place it into the water guard. Make sure it
is standing in an upright position. (The water bottle is not
included.)
2.
DO NOT plug in the water dispenser until you have checked that
water flows out when either of the faucets are pressed. Never turn
on the water dispenser without water in it. Doing so may cause the
unit to catch fire or malfunction.
3. Check that water flows out by pressing both the Hot and Cold faucets one at a
time.
4. Plug the power cord into an 115Volt / 60Hz outlet.
5. To activate the water heater and cooler, turn ON the red and green switches
on the back of the unit. The hot & cold indicators in the front will be lit.
5
