11
Note:
This washer is to be connected to the water mains using new hoses. Old hoses
should not be used. Do not install your
washing machine in a room where
temperatures may be below freezing.
Frozen hoses may burst under pressure.
If the washer is delivered in the winter
months and temperatures are below
freezing, store the washing machine at
room temperature for a few hours before
putting it into operation.
Drain system
• To prevent water leakage, do not place the drain hose
higher than 96 inches from the bottom of the washer and
secure drain hose tightly and securely.
Using the provided clamp connect the drain hose to the
washer.
Note:
1) Drain hose, clamp, drain hose holder and tie
strap are placed in the accessory bag in the
drum.
2) Use tie strap to secure the drain hose to a stand
pipe, inlet hose or laundry tub.
3) Care should be taken so the drain hose
is not immersed in water.
Level the Washer
• Leveling the washing machine properly prevents excessive
noise and vibration. Install your washer on a solid and level floor
surface.
• If the floor is uneven, adjust the adjustable legs as required. The legs
can be extended to level the washer. The more the legs are extended,
the more the washer will vibrate.
• Use a level to make sure that the washer is perfectly level.
• Leveling of your washer must be done while the washer is spinning
with a load. Use a wrench to adjust the legs until there is no vibration. Once done,
tighten the lock nuts to level the washer.
Note:
Do not lift the washer using the dispenser drawer or door as a handle.
steps to Level the washer (As shown in the figure)
1. Loosen the lock nut using a wrench.
2. Level the washer by turning the adjustable legs.
3. Turn the lock nut on each leg towards the base of the
washer with a wrench.
4. Once leveled tighten lock nut against the housing.
English
Cold
Hot
Elbow
Coupling End
Straight
Coupling End
