Haier HWD9050AN1, Руководство пользователя

Страница: 8 / 36

8
Make sure the hose joints and connections are firm and there is no
leakage
Make sure not to damage the electric cable and the plug. If damaged
have it replaced by an electrician
Install the appliance on a solid and level surface ensuring it has 20mm
clearance on each side. The appliance must not be installed on any
textured floor coverings (eg carpet, rugs).
New hose sets provided with the appliance should be used to connect
the washer to the water mains. Old hose sets should not be re-used.
We recommend the inlet hose(s) are changed every 5 years.
WARNING:
Failure to do so may result in a flood and damage to property.
Servicing & Disposal
A damaged electrical cable must be replaced by a Haier service
technician or similarly qualified person. Do not use the appliance until
it has been repaired.
Water supply requirements:
Inlet water pressure: Max. 1MPa (Xpsi), Min. 0.05MPa (Xpsi)
Inlet water flow rate: Min. 0.15 litres/minute
A pressure-reducing valve must be installed if pressure is higher
than 1 MPa.
For optimum wash performance check the supply pressure is
within the recommended range.
When disposing of the washer, it is recommended that the door is
removed to avoid children getting trapped inside, and that the electrical
cable is cut off close to the washer.
NZ AU
8