21
15 Fault Clearance
State
Phenomenon
Solution
Before operation
There is a small amount of water in
the drain pipe and washer-dryer when
using for the first time
The washer-dryer does not operate
Check whether power failure or abnormal power supply occurs
Check whether the power plug is firmly plugged in the socket
Check whether the fuse of power supply or the current breaker
is in good condition
Check whether the power switch is pressed
Check whether the water tap is turned on
Check whether the “delay” function is activated
Check whether the “Start/Pause” button is pressed
Check whether the water tap is tured on and whether water
supply cut-off occurs
Check whether the washer-dryer inclines or shakes
Abnormal noise
Check whether there are foreign bodies such as coins and
zippers in the washer-dryer
Check whether the noise is from the draining pump or motor in
normal operation
Check whether the water inlet filter screen is clogged (If
necessary clean it)
Check whether the water tap and water inlet pipe are frozen
Check whether the “Delay” program is selected
Check whether the “Start/Pause” button is pressed
Check whether the water inlet pipe is bent
Check whether the water pressure is too low
Buttons cannot be operated
No water feed or slow water feed
Water leakage occurs at the water tap
Check whether the“child lock”function is activated
Check whether the shape of water tap is suitable
Check whether the water inlet pipe joint is installed in place
Check whether the water tap is damaged
Refer to the instructions under the title of “Cancel or reselect a
program in the process of running” in the sectionof “13.Other
Functions”
When wash
It is normal and the water is the remaining water of factory
inspection
The following phenomena are not necessarily faults of the washer-dryer. Please check against the
following table before call for servicing. If any fault actually exists, please contact our After-sales Service
Department and do not repair by yourself. Please unplug the power plug before check.
22
State
When rinse
Dewatering
When drain
Others
n
o
it
u
l
o
S
n
o
n
e
m
o
n
e
h
P
Poor washing effect
Forceless washing
Stop operation during washing
Repeated rinsing
No spinning
Loud noise when spinning
Vibration and displacement
The clothes are not spun dry agter
finishing the spinning progran
No water discharge or slow water
discharge
The control panel is partially hot
The washing does not end after the
preset delay time
The washer-dryer’s program is set with discharge time and the
spinning starts after a period of time
Check whether the clothes intertwist
Check whether all the packaging bolts are removed
Check whether the clothes intertwist
Check whether the washer-dryer collides with other objects
Check whether there are forergn bodies in the washer-dryer
The spinning effect varies with type of clothes
Check whether eccentric protection functions due to few clothes
Check whether thedrain pipe is bent, clogged or frozen
Check whether the outlet of drain pipe is 10cm above the floor
Check whether the filter is clogged
It is normal that electronic components are a bit hot
Poor water feeding/drainage conditions or unbalanced clothes
distribution results in longer time
Check whether the washer-dryer is level (The feet can be
adjusted to level the washer)
Check whether sudden power failure or power supply cut-off
occurs
Check whether the “Srart/Pause” button is pressed
The washer-dryer with the function of automatic shutdown upon
clean detected automatically increases or decreases the times
of rinsing (1-2 times) according to the degree of dirtiness of the
clothes
Check the detergent for proper type and dosage
Check whether a proper program is selected
Check whether the clothes weight exceeds the washer-dryer’s
rated washing capacity
