°C
60
°C
40
Function
Selection
Delay
°C
60
°C
40
Function
Selection
Delay
8
Control panel -
function buttons
6a-“Function“ (button a)
Touch it to select sequentiall
T
T
y required functions and settings.
The related symbol will flash.
-
:
temperature function
C°
= cold/15/20/30/40/60/90
-
: spin speed function
:
0/400/600/800/1000/1200/1400 rpm
-
: extras rinse function ad
:
ds 1-2 rinse cycles. Pr
. eferable
ff
p
to better flush out possible residues.
6b-“Selection“ (button b)
Touch it to select heating temperatur
T
T
e, spin,
,
speed or extra
,
rinse times acording to the curret chosen function, the r
,
elated
symbol is blinking. Function will be activated after “Star
.
t/Pause”
button is touched.
6c-“Delay“ – End time dela
a
a
y (button c)
a
a
T
T
h
l h
ouch it to light up r
T
T
T
l
d
b l
d d l
elated symbol and display pr
aa
esent pro-
gramme end time.Accordingly to all programme settings start
of wash cycle will be delay
aa ed.
End time delay could be incr
aa
eased by turning propgramme se-
lector in steps of 30 minutes from 0,5-24h. F
. or example display
aa
off “6:30” means end of programm cycle will be in 6 hours
and 30 minutes. Function will be activated after “Star
.
t/Pause”
button is touched.
It is not applicable to programme “Spin/Drain” and “Self Clean”.
Note: End time m
:
ust always be longer than pr
aa
ogramme cycle
time. Otherwise operation will star
.
t immediately,
yy although
,
chosen end time could not be r
chosen end time could not be r
eached.
eached.
“Child lock“ - contro
rr l panel lock f
k unction
(button a + c)
This option blocks all panel elements against activation. After
starting a programme press simultaneously “Fu“Delay”
a
for about 3 seconds.
ff
Panel lock symbol is no
.
w display
aa ed. Next
.
repetition deblocks any function. F
. or unlocking please press
again the two buttons
W
To get best r
T
T
esults in each programme Haier has well defined specific default settings.
If there is no special requirement default settings are recommended.Accordingly to
these factory settings many programme parameters and additional functions could be
individually changed (see “programmes” and “function” buttons).
c
a b
--°°
