Haier HW010-CP1439, Руководство пользователя, Страница: 25 / 65

EN
10-Installation
25
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
10.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 10-3).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-4).
10-4 10-3
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environ-
mentally friendly manner.
10.2 . OPTIONAL: Adjusting the bottom cover
board
When opening the shrink package, you will find a
calcium-plastic board (A) (Fig. 10-1). The board is
used for reducing noise after covering the bottom of
the cabinet.
2. Lay the washing machine down to its side,
porthole pointing upwards, bottom side towards
operator and screw off the four bolts (Fig. 10-2).
3. Place the calcium-plastic board.
Screw the bolts through the four holes on the
board on to the tub firmly. Finally set the machine
upright again.
There is also a felt or sponge (B) in the package.
1. Past the felt or sponge on one side of the
calcium-plastic board (Fig. 10-1).
The felt or the sponge is pointing inside
the appliance.
10-1
A
B
1.
2.
3.
10-2
A