CLEANING
AND
MAINTENANCE
17
CLEANING
AND
MAINTENANCE
18
Exterior
Before switching on again ensure that
all controls are in the off position.
Make sure that the oven grill and hobs
are sufficiently cool before you start
cleaning.
Never mix different cleaning products as
different active ingredients may react with
unforseen results.
Turn off at the mains before cleaning.
Use a damp cloth to clean the outside.Never
use any sharp instruments, abrasive household
cleaner, or detergents for cleaning.For hard
stains use suitable washing liquid.
Control panel
Wipe over the control panel with a damp cloth
and polish with a dry cloth. Do not use oven
cleaners or aerosols,scouring pads or abrasive
powder for cleaning the plastic knobs or end
caps as damage will occur. Do not attempt to
remove any of the control knobs from the
panel as this may cause damage and is a
safety hazard.
Grill interior
Wipe the grill elements with a damp cloth
(ensuring they are sufficiently cool first)
to remove any fat spashes. This will prevent
fumes from any fat being burned off when
the cooker is next used.
Oven interior
Remove the rod shelves for washing in the
sink. Use a fine steel wool soap pad for
removing stubborn stains from the rod shelves
and floor of the oven. Take care during
cleaning not to damage, bend or dislodge
from the surrounding clips the thermostat
sensor which is located at the top right hand
side of the oven
Door
removal
In order to obtain easier access to the oven
chamber for cleaning , it is possible to
remove the door.
To do this, tilt the safety catch part of the
hinge upwards. Close the door lightly, lift
and pull it out towards you. In order to fit the
door back on to the cooker, do the reverse.
When fitting, ensure that the notch of the
hinge is correctly placed on the protrusion
of the hinge holder. After the door is fitted
to the oven, the safety catch should be
carefully lowered down again. If the safety
catch is not set it may cause damage to the
hinge when closing the door.
Before any maintenance is started
involving electrical parts, the
appliance must be disconnected
from the power supply.
If the oven has been in use, let the
oven cavity and the heating elements
cool down before attempting any
maintenance.
Changing the bulb
Unscrew the protective cover. We
recommend that you wash and dry the
glass cover at this point.
Carefully remove the old bulb and
insert the new bulb suitable for high
temperatures (300
℃
) having the
following specifications: 220-240V,
50Hz, 25W, G9 fitting.
Refit the protective cover.
IMPORTANT
Never use screwdrivers or other
utensils to remove the light cover.
This could damage the enamel of the
oven or the lampholder. Remove only
by hand.
IMPORTANT
Never replace the bulb with bare
hands as contamination from your
fingers can cause premature failure.
Always use a clean cloth or gloves.
Please note:
The bulb replacement is not covered
by your guarantee
l
l
Tilting
the
hinge
safety
catches
Door
removal
