Haier HI6LMK, Руководство пользователя

Страница: 8 / 8

INSTALLATION INSTRUCTIONS CONT.
PAGE 8 ● SET UP & CARE
15. Insert supply line fully into water valve inlet. Slide ferrule (sleeve) into valve
inlet and fi nger ‐ ghten compression nut onto valve being careful not to
cross ‐ thread. Tighten another half ‐ turn with a wrench. Do not over ‐ ghten.
Do not use Te fl on tape on threads.
Valve Inlet
Water Supply Line
14. Locate water valve on rear of refrigerator. Valve protrudes slightly through
rear compartment cover.
13. Re ‐ install freezer shelf on lowest rail as shown and place ice bucket under
the ice maker. Raise wire control arm on ice maker to OFF posi on.
Wire Control Arm
Lowest Rail
P/N 0060517641 Rev A
PAGE 9 ● SET UP & CARE
1. Turn o ff water supply at shut ‐ o ff valve.
2. Connect copper water supply line to household water system.
3. Turn ON water supply and ghten any connec ons that leak.
4. Coil excess water supply line behind refrigerator, as shown below and arrange coils
so they do not vibrate or wear against other surfaces. Use water supply clamp and
hex head screw to secure water supply line to rear of refrigerator.
Water Supply
Clamp
Hex Head
Screw
6. Reconnect refrigerator to power supply.
7. Move refrigerator back into place and level it using instruc ons in User Manual.
8. Turn ice maker ON by lowering wire control arm.
Wire Control Arm
WATER SUPPLY CONNECTION
This water supply installa on is not covered under warranty by
the refrigerator or ice maker manufacturer(s). Follow these instruc ons
carefully to minimize the risk of expensive water damage.
!
WARNING
Supplies Required for Installa on:

Access to a household cold water line with water pressure between 20psi and 120psi.

A water supply line made of 1/4 ‐ inch Outside Diameter, copper tubing. To determine
the length of the copper tubing needed, you will need to measure the distance from
the ice maker water valve at the back of the refrigerator to your cold water line. Then
add approximately 7 feet for the refrigerator to be moved out for cleaning and
service.

A shut ‐ o ff valve to connect the water supply line to your household water system.
NOTE: Do not use a self ‐ piercing type shut ‐ o ff valve.

A compression nut and ferrule (sleeve) for connec ng the water supply line to the ice
maker inlet valve. See page 4 for picture.