INSTALLATION INSTRUCTIONS
13
Rear venting
If you want to choose the rear venting mode, the exhaust grill at the front of the dryer
needs to be replaced with the outlet cover from the back panel of the dryer. Gently
open the grill, using a thin tool such as a key. Next, remove the cover from the
back panel and clip it into the grill space at the front panel. The exhaust grill is not
required when using a flexible hose.
Extra Dry
Normal
Off
100min
60min
30min
Start/Pause
HDY-D60
30min
60min
Air Dry
Heat Dry
6kg Sensor Dryer
INSTALL THE FLEXIBLE HOSE
(
optional
Flexible hose)
Duct hole
Outdoor
Flexible hose
Flexible connector
Flexible hose clip
Connect the narrow end of the
connector to the dryer duct pipe mouth
at the back of the dryer. Then connect
the flexible hose to the wide end of
the connector. Use the clip to
fasten connection point between the
flexible hose and connector (fasten clip
with a screwdriver). Extend the flexible
hose through the duct hole, make
sure the flexible hose is not twisted to
allow the air to be vented outside.
Notes: If duct hole is not available at user's home, make sure the flexible hose
is vented through a window.
If the dryer is mounted on the wall in the inverted position, you can not use the
flexible hose.
Correct fixing mode:
Fig.1
Fig.2
Fig.3
diameter
˚
100mm)
The flexible hose should be angled to avoid water running back into the dryer.
Ensure a vent cap is fitted when vented outside.
Vent cap
