Haier HDW12-SFE1 Series, Руководство по эксплуатации

Страница: 16 / 24

14
Interrupting the programme
Cancelling or modifying a cycle while underway
Open the door.
Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully
until spray arm has stopped rotating.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, “Loading the
detergent ”).
To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled
“Reset drain function”, and select the programme you wish (see the paragraph entitled, “Switching the
dishwasher ON”).
en
Notice:
Interrupt or cancel a programme in progress ONLY when absolutely necessary.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Set On-Off button to Off
Open the door .
Turn the water tap off.
Remove dishes, etc. when they have cooled down.
Reset drain function
You can use Reset drain function to stop the washing cycle under running by pressing and holding the
“C1” and “C3” for 3 seconds, and the appliance will stop after a few minutes drain phase.
C3 C1
Notice:
When the appliance is already underway press the button "B" for 3 seconds, all of
the settings will be cancelled.