Notice:
W
hen washing, the knob will not rotate itself.
T
urning on the Appliance
Starting a wash cycle...
M
ake sure that the plug for the appliance is inserted into the wall socket.
Make sure that the water supply is turned on to full pressure.
Load the dishes.
Pour in the detergent.
Press the "POWER" button, and the “END” light will turn on.
Turn the knob located on the right of the control panel until the number or symbol for the cycle setting is
aligned with the refrence mark (see the section entitled, program overview).If the knob rightly aligned with
the refrence mark you want to choose, you must turn the knob to with the mark of “RESET” .Then back to
first step.
After five seconds the “END” light will turn off, the wash cycle will begin.
When the buzzer constantly beeps six times, the “END” light will turn on and the cycle has finished. Turn off
the appliance using the "POWER" button, turn off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are
still hot and more susceptible to breakage. They will also dry better.
A
t the end of the wash cycle...
A
cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent
may have already been used, and the appliance may have already drained the wash water. If this is the
case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent").Rotate
the knob to the mark of “RESET” then select right programme.
C
ancelling or modifying a wash cycle setting...
6
