Haier HB21FWRSS, Инструкция по установке и эксплуатации

Страница: 16 / 30

- Short term fresh or frozen food can be placed in the upper section of the refrigerator
or in the top freezer drawer respectively. Store raw foods in the lower area of the
refrigerator away from ready to eat food in the top area.
- The height of the cantilever shelves can be adjusted to fit your storage needs.
When adjusting the height of the shelf, first remove any food placed on the shelf. Tilt
the front of the shelf upwards then pull it to unlatch the rear hooks (fig 1) . Place the
hooks in a new ladder slot location and tilt back down into position on an even
horizontal plane (see pictures to the right).
Make sure that the two sides of the shelf are in level
positions otherwise the shelf may fall down or the
food may drop off.
- Crisper use
The refrigerator is designed to include a fruits, vegetables and/or deli crisper. Its
inside temperature can be adjusted according to the type of food being stored.
Turn up the humidity control button located on the right side of the crisper (fig 2), to
increase the humidity inside. In doing this the crisper is suitable for storing
cucumbers, grapes, oranges, apples, peaches, lettuce and other produce with a high
moisture content.
Turn down the humidity control button to lower the humidity in the crisper, suitable for
storing meats, cheeses, onions and other drier foods.
- Full width pantry
The refrigerator is specially designed to include a full width pantry with a temperature
which can be adjusted depending on the type of food to be stored in there.
Air regulator
button
Note: Don’t press the air-regulator button too hard, to avoid any damage.
- Bottle rack height adjustment and cleaning
Hold both sides of the bottle rack then lift and pull it straight out for cleaning or to
change location (fig 3).
After cleaning, the bottle rack can be installed in the reverse manner, and the
position can be adjusted according to the height of the food to be stored.
- Crisper cover removal
Lift up the shelf, then pull it straight out in the direction shown (fig 4).
When adjusting the height of the bottle rack, it is better to house
the dairy bin above the bottle rack.
Fig 1.
Fig 2.
Humidity control
button
Fig 3.
Fig 4.