3
English
FEATURES DIAGRAM
Part Names
OPERATING INSTRUCTIONS
Remote Control
The Remote Control requires 2 AAA batteries (not supplied) for operation.
To install the batteries, simply depress the back of the remote with your thumb in the indentations and
remove the cover. Insert the batteries according to the diagram shown inside. Replace the cover.
• Pick up the fan carefully and place it on a solid surface. Plug this appliance into a grounded outlet only.
Check the voltage, which should be 120 V.
• Turn the fan on by pressing the Speed button (ON/SPEED) on the remote control or on the control panel.
The appropriate LED light on the front of the fan will illuminate.Turn the fan off by pressing the OFF button.
• The speed is adjusted by repeatedly pressing the Speed button (ON/SPEED) on the remote control or on
the control panel.
I = Low speed II = Medium speed III = High speed
The appropriate LED light on the front of the fan will light up.
Ionizer
The ionizer feature is activated when the fan is turned ON and deactivated when the fan turned OFF. The
ionizer releases negative ions into the outgoing air. These particles take on a negative charge and attract
positively charged particles, such as dust and pollen. Over time, you may see a buildup of particles on the
front grill. These can be removed using a soft damp cloth as instructed in the Cleaning/Maintenance section
of this manual.
Adjustment
Oscillation Control
To start and stop oscillation of the fan head, push the Oscillation button (OSC) on the remote control or the
SWING button on the control panel. The appropriate LED light on the front of the fan will light up.
STAND ASSEMBLY
1. Use the 4 M5x10 screws to connect the stand bracket to the motor bracket (Fig. 1)
2. Use the 4 ST4x20 screws (found on the base) to connect the base and the stand. (Fig. 2)
3. Loosen the lock screw by turning counter-clockwise, then extend the base to the desired height. Tighten
the lock screw by turning clockwise to fix the height. (Fig. 3)
4. Align the hole in the extended tube with the hole in the stand bracket and connect them with 2 M4x20
screws. (Fig. 4)
5. Turn the fan right side up for operation.
A. Mode
B. Time
C. Swing
D. Off
E. On/Speed
