2
English
Features Diagram
PART NAMES
OPERATING INSTRUCTIONS
1. Plug the power cord into as wall outlet (120VAC 60Hz).
2. To make the fan head oscillate, push in the Oscillating Knob, located on the top of the Motor Housing.
3. To adjust vertical angle, tilt fan head up or down.
4. To adjust height, loosen the Height Adjustment Knob (Figure 2) and adjust fan to the desired height. Re-
tighten the Adjustment Knob before turning fan on.
5. Speed is controlled by reversing the rotary switch.
GUIDE TO BETTER FAN MAINTENANCE
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly remove soap
film with clean water.
3. To disassemble each part, reverse the order of assembly.
ASSEMBLY INSTRUCTIONS
1. Loosen and remove the four screws from bar A and bar B (Fig 1). Cross the 2 bars as shown and align
the four holes with those on the Flange. Secure the Flange to the bars with the four screws. Slide the Base
Cap down over the assembly.
2. Unscrew the Grille Lock Nut from the shaft end of the Motor Housing. 3. Mount the Rear Grille to the
Motor Housing by matching the 2 holes on the Rear Grille to the 3 round pins on the front of the Motor
Housing. Push in firmly until the 2 pins protrude through the 2 holes.
3. Secure the Rear Grille to the Motor Housing with the Grille Lock Nut.
4. Insert the Blade on to the Motor Shaft, matching the slots on the back of the Blade with the Shaft Pin (Fig.
2). Secure Blade with Blade Cap, turning counterclockwise to tighten.
5. Test Blade operation by rotating it with your hand. There should be no friction with the Grille Lock Nut. If
Blade does not rotate freely, repeat steps 3 through 6.
6. Mount the Front Grille to the Rear Grille by positioning the hook on the Front Grille over the top of the
Rear Grille. Secure the two Grilles with the 4 Clips attached to the Front Grille (Fig. 2).
