2
English
Features Diagram
PART NAMES
ASSEMBLY OF FAN PEDESTAL ONTO FAN BASE
1. Insert the pedestal onto the base, press the pedestal firmly into position in the base.
2. Finally, locate screws provided in the underside of the base and tighten firmly to secure the
pedestal and base permanently together.
ASSEMBLY OF BLADE AND GRILLES
1. Discard sleeve on shaft.
2. Unscrew the spinner clockwise and the grill lock nut counterclockwise then remove both of them
with the plastic sleeve around motor shaft.
3. Set the rear grill in the proper position with HANDLE UP.
4. Screw on plastic Grill Lock Nut tightly to attach grill.
5. Install the blade onto the shaft until it reaches the retaining pin.
6. Screw spinner on to motor shaft counter clockwise.
7. Test Blade operation by rotating it with your hand. There should be no friction with the Grill Lock
Nut. If Blade does not rotate freely repeat step 2 through 6.
8. To attach the Front Grill onto the Rear Grill, put the Grill Ring around the Rear Grill. The lip of the
grill should locate into the inner rear channel of the Grill Ring.
9. Tighten the Ring Screw a little to prevent the ring from slipping off.
10. Slip the Front Grill into the inner front channel of the Grill Ring and when both grills are correctly
positioned tighten Ring Screw to secure the grills.
OPERATING INSTRUCTIONS
1. This fan is for HOUSEHOLD USE and plugged into electrical wall outlet.
2. To make / stop the fan head oscillate, push down / pull the oscillating control knob on the motor
housing.
3. To adjust vertical angle, tilt fan head up or down as desired.
4. Speed is controlled by depressing the piano keys.
5. Check front grille is securely fixed before operation.
