Haier DW9-AFM ME, Руководство по обслуживанию

Страница: 6 / 20

Serial Number: Version:00.00 Edition: 2005-7
Dishwasher
Model: DW9-AFM
Page 6 of 20
5.3 Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas) connector and make sure that it
is fastened tightly in place (see Fig 1).If the water pipes are new or have not been used for
an extended period of time,let the water run to make sure that the water is clear and free of
impurities.If this precaution is not taken,there is a risk that the water inlet can get blocked
and damage the appliance.
5.4 Hot Water Connection
The water supply to the appliance can also be
connected to the house's hot water line (centralised
system, heating system), as long as it does not exceed a
temperature of 60
℃
In this case, the wash cycle time will be shortened by
about 15 minutes and the wash efficiency slightly
reduced.
The connection must be made to the hot water line
following the same procedures as those for the
connection to the cold water line.
Attention:
The special plastic hose support must be solidly
fastened to the wall to prevent the drain hose from
moving and allowing water to spill outside the drain.
Electrical Connection
After making sure that the voltage and frequency values
for the current in the home correspond to those on the rating plate (located on the stainless
steel inner door of the appliance) and that the electrical system is sized for the maximum
voltage on the rating plate, insert the plug into an electrical socket which is earthed properly
(the earthing of the appliance is a safety requirement mandated by law). If the electrical
socket to which the appliance must be connected is not appropriate for the plug, replace the
plug, rather than using adaptors or the like as they could cause overheating and burns.
5.5 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the
sink, making sure to avoid bending or crimping it. Use the special plastic support that comes
with the appliance (see Fig.2). The free end of the hose must be at a height between 40 and
100 cm and must not be immersed in water.