Haier DW12-TFE1 series, Руководство по обслуживанию, Страница: 22 / 50

21
Service Manual
Model No.DW12-TFE1 DW12-TFE2
Issue
Rev.
6. How to fill the salt
6-1. Salt
The hardness of the water varies from place to place. If hard water is
used in the dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the water.
6-2. Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
--When the low salt indicator “F” lights, you must fill
the salt.(DW12-TFE2 series).
--Remove the lower rack and then unscrew and remove
the cap from the salt container;
--If you are filling the container for the first time, fill it with
water;
--Place the end of the funnel (supplied) into the hole and
introduce about 2 kg of salt. It is normal for a small
amount of water to come out of the salt container.
--Carefully screw the cap back on.
Important
To prevent the formation of rust, load the salt just before beginning a wash cycle.
6-3. Adjusting salt consumption
The dishwasher is designed to allow for adjusting the Amount of salt consumed based on the
hardness of the water used.
This is intended to optimize and customize the level of salt
consumption so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
--Unscrew the cap from the salt container;
--There is a ring on the container with an arrow on it (see figure to
the side),
--If necessary, rotate the ring in an anticlockwise direction from the
"-" setting towards the "+" sign, based on the hardness of the water being used.
F