Serial Number: Version:00.00
Edition: 2005-7
Dishwasher
Model: DW12-CBE5/6
Page 7 / 21
In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly
reduced.
The connection must be made to the hot water line following the same procedures as those for the connection
to the cold water line.
5.14 Anti-Flooding Protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the
water supply hose, or leaks within the unit, in order to prevent damage to your
home. If for any reason the box containing the electrical components happens to
get damaged, remove the plug for the appliance from the socket immediately. In
order to guarantee that the anti-flooding feature operates properly, the "A" box
with water supply hose must be attached to the water supply tap as shown in
Fig .1.No other type of connection is acceptable. The water supply hose must not,
under any circumstances, be cut, as it contains electrical parts which are live. If
the length of the hose is not adequate to make a proper connection, the hose
must be replaced with one which is long enough. This hose is available upon
request from specialized retailers and service centers.
5.15 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink, making sure
to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see Fig.2). The
free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.
5.16 Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to those on
the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is
correct for the maximum voltage on the rating plate, insert the plug into an electrical socket which is earthed
properly (the earthing of the appliance is a safety requirement mandated by law). If the electrical socket to
which the appliance must be connected is not appropriate for the plug, replace the plug, rather than using
adaptors or the like as they could cause overheating and burns.
