6
6
SERVICE MANUAL
. External views
Chapter 3 Installation, adjustments
●
and maintenance
3-1. Unpacking
1. Remove all packaging material; this includes the foam base and all adhesive tape holding the
●
freezer
accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
●
freezer.
3-2. Adjusting
1. The freezer is designed for freestanding installation
●
only. It should not be recessed or built-in.
2. Place the freezer on a floor strong enough to support it fully loaded.
3. When moving freezer, never
●
tilt it more than a 45-degree angle. This could damage the compressor
and the sealed system.
4. If freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to allow
the refrigerant to settle.
5.Proper Air Circulation
To assure the freezer works at the maximum efficiency it was designed for, you should install it in a
location where there is proper air circulation, Plumbing and electrical connections.
The following are recommended clearances around the freezer:
Door
Control panel
Handle
