Haier 636 Series, Руководство пользователя

Страница: 23 / 96

GB
9-Troubleshooting
23
Program Cause Solution
F3
• Temperature sensor error. • Contact the After sales service.
F4
• Heating error. • Contact the After sales service.
F7
FA
• Motor error. • Contact the After sales service.
FC1
or
FC2
• Abnormal communication error. • Contact the After sales service.
UnB
• Unbalanced load error. • . m u r d e h t n i d a o l y r d n u a l e c n a l a b d n a k c e h C
Reduce the load.
Problem Cause Solution
Washing machine fails
to operate.
• Programme is not yet started. • Check programme and start it.
• Door is not properly closed. • Close the door properly.
• Machine has not been switched on. • Switch the machine on.
• Power failure. • Check power supply.
• Child lock is activated. • Deactivate child lock.
Washing machine
water.
• No water. • Check water tap.
• Inlet hose is kinked. • Check inlet hose.
• •
• Water pressure is less than 0.03 MPa. • Check water pressure.
• Door is not properly closed. • Close the door properly.
• Water supply failure. • Ensure the water supply.
Machine is draining • Height of drain hose is below 80 cm. • Make sure that drain hose is
properly installed.
• Drain hose end could reach into
water.
• Make sure the drain hose is not
in water.
Drainage failure. • Drain hose is blocked. • Unblock drain hose.
• •
• Drain hose end is higher than 100 cm
above fl oor level.
• Make sure that drain hose is
properly installed.
Strong vibration while
spinning.
• Not all transportation bolts have
been removed.
• Remove all transportation bolts.
• Appliance has no solid position. • Ensure solid ground and a levelled
position.
• Machine load is not correct. • Check load weight and balance.
Operation stops
before completing
wash cycle.
• Water or electric failure. • Check power and water supply.
Operation stops for
a period of time.
• Appliance displays error code. • Consider display codes.
• Problem due to load pattern. • Reduce or adjust load.
• Programme performs soaking cycle. • Cancel programme and restart.
9.3 Troubleshooting without display code
FC0
、
Water level sensor error. • Contact the After sales service. •