Hague Quality Water WATERMAX LC100P, Руководство по установке владельца

Страница: 42 / 48

Troubleshooting, Cont.
Problem Possible Cause Solution
Increase in product TDS See “High product water TDS”
Carbon Post-Filter exhausted Replace Carbon Post-Filter cartridge
Tank and appliance contaminated Replace Pre- and post-Filter, sanitize tank and
appliance
Tank contaminated Sanitize tank
Tank diaphragm slipped Replace tank and postfilter cartridges
Bad tasting water
Carbon Post-Filter cartridge not flushed
completely Flush one or two tanks of product water
through Post-Filter
Cloudy water
Dissolved air in feed water, which is
concentrated in product water This condition usually clears up eventually as
the condition of feed water changes. Letting
water stand will allow dissolved air to dissipate
Increase in product TDS See “High product water TDS”
Dissolved air in feed water which is
concentrated in product water
Contact your local Hague dealer
Cloudy ice cubes
Certain ice cube shapes trap more dissolved
air than others. The larger, more squared off
cubes are the clearest. Smaller, rounded
surface ice cubes are cloudier Change ice cube mold shape, make cubes
manually if using automatic. Let water sit to
release dissolved air before freezing
RO membrane is bad
Membrane fouled, hydrolyzed, ruptured or
attacked by bacteria Replace membrane
Pre- or Post-Filter leaks
from housing
Deformed or stretched O-Ring or housing not
tight Replace O-Ring and clean seating surface or
tighten housing
Flow/pressure control
plugged
Dirt or debris plugging flow restrictor tube Replace flow restrictor/pressure control
Spigot-valve leaks
through spout
Valve seat is defective Repair spigot assembly, P/N 10271
Air gap overflows
Debris is lodged in 3/8-inch tube from air gap
to drain Disconnect the tube from drain saddle and
clean out debris
Handle breaks off
Fatigue or misuse Repair spigot assembly, P/N 10271
Spout breaks off
Fatigue or misuse Replace spout assembly, P/N 200350
Valve leaks around stem
Fatigue Replace stem assembly, P/N 10271
Leak at base of spout
Fatigue Repair spigot assembly, P/N 10271
Tank-Loss of Air
Tank may lose air over a period of time Adjust air pressure between 5 and 7 PSI
Slipped diaphragm
Pressure exceeds diaphragm strength due to
combination of high feed pressure and low
precharge, or defective tank Replace tank
WaterMax RO Owner’s Manual 11/11/2009 42