Hague Quality Water WATERMAX 60 SERIES, Руководство по установке владельца

Страница: 46 / 52

WaterMax 60 Series Owner’s Manual 11/10/2008 46
WaterMax
®
Filter Specifications
The following table describes the available filters.
Filter Purpose
61AAN
Removes iron and iron algae and bacteria. Reduces manganese. Also removes up to 5 ppm Hydrogen
Sulfide with the presence of 2 ppm iron. For regeneration frequency, see
61AAN WaterMax ® Filter
Sizing Formula for this model.
61AAE-BWO
Removes tastes, odors and will reduce most man-made pollutants. Backwash every 3 days or as
needed.
Warning: Must not be backwashed for 24 hours after installation.
61AAR-BWO
Removes suspended matter (turbidity) from water down to the 20–40 micron range. Backwash every
3 days or as needed.
61AAS-BWO
Will raise the pH of most low pH water. The mineral media must be replenished periodically to
maintain optimum bed depth for effective correction. Backwash every 2 days to prevent solidification of
mineral media.
61AAF-BWO
Removes suspended matter (turbidity) from water down to nominal 20 microns. Backwash every
3 days or as needed.
Refer to the following specifications for the
WaterMax
®
water filtration appliances 60 series
.
61AAN 61AAE-BWO 61AAR-BWO 61AAS-BWO 61AAF-BWO
Capacity (ppm)
10,000 N/A N/A N/A N/A
Sulfur H
2
S
5 N/A N/A N/A N/A
Iron (ppm)
20 N/A N/A N/A N/A
Minimum pH
7 N/A N/A 5 1 N/A
Media type
Manganese
Greensand
(N)
Activated Carbon
(E)
Filter Ag
(R)
Calcite/Corosex
(S)
Multi-Grade
(F)
Media amount (cu. ft.)
1.25 1 1.25 1.25 1
Cont. flow rate (gpm)
6 6 6 6 6
Peak flow rate (gpm)
10 10 10 10 12
Backwash rate (gpm)
7 5 5 7 7
Brine line flow control (gpm)
0.5 N/A N/A N/A N/A
Water Pressure
30–120 30–120 30–120 30–120 30–120
Mode settings
1 1 1 1 1
Backwash #1 (min)
5 7 7 7 7
Brine/rinse (min)
45 0 0 0 0
Backwash #2 (min)
3 0 0 0 0
Salt (lb) 3 lb salt setting=4 oz
KMnO
4
2
3 0 0 0 0
Regenerant used
4 oz KMnO
4
N/A N/A N/A N/A
Flow rate at 25 psi drop
16.7 gpm 21.4 gpm 21.5 gpm 20.4 gpm 19.4 gpm
Flow rate at 15 psi drop
10.5 gpm 15.9 gpm 15.9 gpm 15.2 gpm 15.1 gpm
Service flow @ pressure drop 3
4.5 gpm @ 4.7 psi 3.6 gpm @ 1.1 psi 4.5 gpm @ 1.5 psi 4.5 gpm @ 1.8 psi 3.6 gpm @ 1.5 psi
1
The 61AAS-BWO will raise the pH of most, but not all low pH water. Some water requires chemical injection using a chemical feed pump.
2
Caution: Follow the instructions on the KMnO
4
container.
3 For optimum water quality, do not exceed recommended service flow rate for filter media type.