Hagie 2101, Дополнение к руководству оператора

Страница: 18 / 61

15
III.
PREPARING TO OPERATE
ATTACHING QUAD PULLERS
1. Attach the quad pullers to each lift arm tool bar (fig. 3.13).
2. Install the stalk guides to the quad puller head assembly
(fig. 3.14, item 3).
3. Attach the deflector shield mount tube (fig. 3.14, item 1)
and the deflector shields for right or left hand deflection (fig.
3.14, item 2).
4. Refer to page 16 for information about installing hydraulic
hoses.
5. Normal operating angle of the quad puller is obtained when
the tool bar mount surface is parallel to the ground (fig.
3.15, item 1). This angle can be varied by an adjusting bolt
(fig. 3.15, item 2) and slot (fig. 3.15, item 3).
6. Adjust tire pressure to approximately 10 pounds.
NOTE:
Be sure all four tires have equal
pressure. Check tire pressure daily.
NOTE:
Some quad pullers may come pre-assembled to the tool b
ar. In this case, you would attach them to the lift assembly.
FIG 3.15
1
2
3
FIG 3.13
FIG 3.14
1
2
3