Hagerman Audio BUGLE2, Руководство пользователя

Страница: 6 / 12

BUGLE2 Phonostage Kit PCB 6
Install opamps into sockets. The dot in the plastic indicates pin1, which is the hole
with the square pad.
Install opamps
The assembly is now ready for initial testing. Connect the power supply to the DC
jack. Plug the supply into the wall, and the LED should turn on. Some of the power
supplies have a few seconds of delay so don’t panic. Disconnect.
Electrical test
Add the grounding bracket using the #6 x 1/4” screw. Make sure the flat surface
faces rearward and is aligned with the edge of circuit board.
Install ground bracket
Modify end panels by drilling 3 holes in each (for RCA jacks, ground, and power).
Modify end panels
Insert circuit board assembly into the bottom section of the plastic enclosure. Do this
by placing end panels (textured surface outwards) onto the RCA jacks and then
dropping into position. Secure in place using the #4 x 3/8” screws.
Insert board into enclosure
Add the #6 x 1/2” ground screw through the bracket and secure using #6 nut. Add
#6 thumbscrew (not too tight).
Install ground post
Turn unit over and add rubber feet. And finally, apply top cover and secure in place
using the four remaining screws.
Add feet and top cover