hager OnAir, Инструкция по эксплуатации

Страница: 5 / 100

5
It is likely, that your radio will find more than one wireless
access point. If this happens, you can choose which one
you want to connect to. Turn the tuning dial on the radio to
see the name for each access point the radio has found.
3. Connect to the wireless network
With the name for the access point you want to connect to
displayed, press
Select .
If your network is not configured to need an encryption
code, the display should show
 

, then
 
.
If the screen displays either
  
or

 
, then the network is using one of the encryption
systems: WEP or WPA and you will need to enter the
correct code to enable the radio to communicate with your
network.
After about 3 seconds, the display goes into the code entry
mode. To enter the code, use the tuning dial to select each
character of the code in turn, pressing
Select
after each
character.
When you have entered the final character, use the tuning
dial to select

and press Select .
The radio should now be able to connect to the network.
The WEP or WPA code would have
been set up by the person who set
up and configured your wireless
network.
Getting started
WEP and WPA codes are sensitive to
upper and lower case characters so
you must enter them exactly.
Make sure the character you want is
shown in the centre of the display
before you press
Select
.