EQ34 GRADE 1 CYLINDRICAL LOCK
INSTALLATION INSTRUCTIONS
I
-
LS02688
Rev 1, Rev Date: 01/12/2023
[27390107]
Page
9
of
7
Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325
-
9995 www.hagerco.com
FCC
Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC
Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the equipment
into an outlet on a circuit different from that to which the receiver is connected, Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications to the device not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Canada
This device contains licence
-
exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada
’
s licence
-
exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained between the user's body and
the device.
Cet appareil contient un ou des émetteurs/récepteurs exempts de licence conformes aux normes Innovation, RSS sans licence de
Sciences et Développement économique Canada. Le fonctionnement est soumis à la suivant deux conditions :
(1) Cet appareil ne doit pas provoquer d'interférences.
(2) Cet appareil doit accepter toute interférence, y compris les interférences susceptibles de provoquer des
Pour se conformer aux exigences d'exposition RF, une distance de séparation minimale de 20 cm doit être maintenue entre le corps
de l'utilisateur et l'appareil.
