7.
The pump must be immersed in water (maximum water
temperature 35°C / 95°F). The pump must not run dry.
8.
Read and observe all the important notices on the appliance.
9.
Do not use this appliance for other than its intended use. The
use of attachments not recommended or sold by the appliance
manufacturer may result in a dangerous situation.
10.
Do not install or store the appliance where it will be exposed to
the weather or to temperatures below freezing.
11.
Do not expose the appliance under sunlight or place at low
temperature for a long period of time.
12.
Make sure the appliance is securely installed before operating it.
13.
If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to arrange
the cord so that it will not be tripped over or pulled.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Only close adherence to these installation, electrical and
maintenance guidelines will ensure the safe and efficient use of
this appliance.
The Exo Terra
®
Reptile Fountain is powered by the Exo Terra
®
Repti Flo 200 Circulation Pump (included). The pump is for indoor,
household use only and is designed to power a variety of appliances
that require a submersible circulating pump such as reptile
fountains, terrarium waterfalls, circulating water parts, etc. The
pump is hermetically sealed to ensure safety and a long lasting life.
Since it does not employ older technologies requiring oil cooling, it
can never leak or contaminate the area with coolant. This pump is
not recommended or designed to transport corrosive or flammable
compounds or liquids with different properties than water. The pump
motor is hermetically sealed with all live electrical parts immersed in
a protective casing to prevent total insulation against water damage
and electrical shock. The motor is extremely compact and energy
efficient, while at the same time producing a continuous output flow.
EXO TERRA
®
REPTILE FOUNTAIN INSTALLATION INSTRUCTIONS
CAUTION
• Disconnect the plug of this and any other submersed appliance
before placing hands in the water.
• The pump must not be allowed to run dry. Check the water level
periodically to ensure water level is sufficient to immerse pump
during operation. Refill water level as necessary.
1. Insert the pump into the Reptile Fountain basin. Press down firmly
on the pump to ensure the suction cups on the bottom of pump
fully secure the pump in place. Attach the pump to the fountain
output tube located in the interior cavity of the rock.
2. Arrange the Reptile Fountain in it’s final position in the terrarium.
The Reptile Fountain should be placed on a flat, level surface.
3. Fill the basin with enough water to cover the pump.
4. Plug in the unit. If the unit does not start immediately, verify
that the water level is sufficient to immerse the pump during
operation. If the problem persists, see the “Trouble-shooting” and
“Maintenance” sections of this manual for further information.
ENGLISH
FRANÇAIS
ESP
AÑOL
