Battery Installation - Transmitter Pad
The Transmitter Pad uses a CR2032 battery that is expected to last 2 years in normal
operation (4 open/close cycles per day). The LED will begin to blink after 5,500
operations to signal that the battery needs to be replaced. We strongly recommend that
the battery be replaced on an annual basis to insure continued reliability.
During initial installation,
remove the red ribbon to activate
the installed battery
To replace the battery, insert a
small flat blade screwdriver into
the battery tray slot as shown
Press the screwdriver in and
down to release the battery tray
Replace old battery with fresh CR2032
making sure that the positive (+) side of the
battery is facing down in the battery tray
Slide the battery tray back into the transmitter
housing and snap into place
Installation Instructions – Receiver Latch
The StealthLock is designed to operate within non-mettalic cabinetry. Use with other
materials may limit or prohibit operation of the lock. We recommend testing the lock if
using in a material other than wood. Batteries should be installed before installation.
The StealthLock kit is designed for
mounting in cabinets with solid panel
construction and full overlay doors. Tips for
mounting this kit in other cabinet types can
be found at www.stealthlock.com
Step #1 - Position the Receiver Latch with
strike plate and installation tool attached as
shown. The front tabs on the installation tool
should contact the front edge
of the cabinet
Note: If door bumpers are used,
then the latch must be spaced/moved
forward to compensate for the
bumper thickness.
Installation Tool Tabs
Front Edge of Cabinet
Step #2 - Screw the Receiver Latch
in place using 4 of the #6 x ½”
screws supplied. If attaching to
material less than ¾” thick,
alternate fasteners may be required.
3
